Nostalgia Electrics CCP810 - Manual (Page 10)

E
N
G
LI
S
H
8
Assembly of Wheels
1. Put #3 Flat Washer onto Axle Bolt (F) and insert into Base Support (I).
2. Put on #3 Flat Washer. Slide Wheel (G) onto Axle Bolt (F), then add a
second #3 Flat Washer, #5 Spring Locking Washer and #6 Nut Cap.
3. Use Wrench (H) to tighten the #6 Nut Cap.
4. On the other side of Base Support (I), insert second Axle Bolt (F) with
#3 Flat Washer, add #3 Flat Washer, second Wheel (G), another #3
Flat Washer, #5 Spring Locking Washer and a #6 Nut Cap.
5. Use Wrench (H) to tighten the #6 Nut Cap.
Assembly of Main Unit
1. Place Main Unit (A) onto the top of the Concession Stand (C).
2. Ensure that the two inserting pins at the bottom of the Main Unit (A) line up correctly
so that Main Unit (A) can be locked under the beam of the Concession Stand (C).
(#6)
Nut
Cap
(#3)
Flat
Washer
(F)
Axle
Bolt
(G)
Wheel
(I)
Base
Support
(#3)
Flat
Washer
(#5)
Spring
Locking
Washer