MyWeigh i5000 - Manual (Page 4)

TARE indicator
Indicates when the reading is stable.
Low battery indicator
PREPARATION
1.Installing batteries/Connecting the AC adaptor
Batteries
Battery Remove the battery compartment
compartment cover cover and insert six batteries(R6P/LR6
/AAsize) into the battery compartment,
take extreme care that the polarities
are correct.
R6P/LR6/AA size
Alkaline batteries.
Battery compartment
AC adapter (optional)
Plug the AC adapter into the AC
AC adaptor adapter socket on the side.
socket The AC input requirement could
be 110,120,220,230 or 240Volts
(50/60Hz) depending on the area
where used, so please verify that
the adaptor is correct
2.Setting up the scale
?
!
CAUTION
Avoid installing the scale in direct sunlight, that may cause discoloration or malfunctions.
Place your scale on a firm weighing table so that the scale is level. (The scale will not
perform accurately when it is not level.)
Place the scale on the firm surface that is flat and level for an accurate weighing.
WEIGHING AND COUNTING
Before weighing
Remember that this scale has an Automatic power-off function.
If this unit is left ON and the stable indicator is displayed, an automatic power-off
function turns power off after approximately 2 minutes of non-use.