MyWeigh MBS 2010 - Manual (Page 2)

D. Wait until the display shows "0.00".
E. The scale is now ready for weighing.
F. Put the baby on the scale.
G. Wait till the display stabilizes.
H. The display shows the baby's weight.
I. Press "ON/OFF/TARE" button and hold for 2 seconds to switch the scale off.
J. If weighing has been completed and the weight on the scale has not changed for 30
seconds, the scale will automatically switch off , to save battery life.
3. To Convert Weight Units (Kilograms or Pounds/Ounces or Stones/Pounds)
Some models read Stones/Pounds. This is a UK Standard whereas 1 Stone = 14lb. Press the
KG/LB button to convert between LB/OZ and KG units. This can be done at any time during
weighing. IMPORTANT: The scale will default to the last weight unit used. *The display will
notate "KG" or "LB" to tell you which mode the scale is in (USA version only).
4. Use of the HOLD button
A. Due to the baby's constant movement on the tray, the displayed weight may be hard to
read. It may constantly change. This is when the HOLD function is used.
B. Press "HOLD" button
C. The display shows "hold" and calculates the average from the various weight readings.
D. The value on the display will be fixed, and in the upper left corner a mark ' " ' will flash.
E. Press "HOLD" again and the display will show the updated weight.
F. Press "ON/OFF/TARE" to turn off the scale.
5. Technical details
Max capacity: 20Kg/44lb - Graduation: 10g/0.5oz
It is important to avoid overloading the scale (don't exceed the capacity)
6. Assembly of Baby Tray
When weighing a baby, assemble the baby tray according to the illustration above. Be certain to
fasten the screws tightly and securely. The Tray must be screwed down tight and securely or
injury can occur!
7. Weighing at older Ages
If the child can stand safely, You can remove the baby tray to allow the child to stand on the