MSI IM-GS45-D - Manual (Page 47)

3-11
MS-9859
Remote Access Configuration
Remote Access
The setting enables/disables the remote access function. When set
to [Enabled], users may configure the following settings for remote
access type and parameters.
Serial Port Number, Base Address, IRQ, Serial Port Mode
Use these settings to configure ports for remote access.
Flow Control
Flow control is the process of managing the rate of data transmis-
sion between two nodes. It’s the process of adjusting the flow of
data from one device to another to ensure that the receiving device
can handle all of the incoming data. This is particularly important
where the sending device is capable of sending data much faster
than the receiving device can receive it.
Redirection After BIOS POST
This setting determines whether or not to keep terminals’ console
redirection running after the BIOS POST has booted.
Terminal Type
To operate the system’s console redirection, you need a terminal
supporting ANSI terminal protocol and a RS-232 null modem cable
connected between the host system and terminal(s). This setting
specifies the type of terminal device for console redirection.
▶
▶
▶
▶
▶
▶