MSI IB-945GC - Manual (Page 20)

2-8
Hardware Setup
▍
M
eMory
These DIMM slots are intended for memory modules.
Installing Memory Modules
The memory module has only one notch on the center and will only fit
in the right orientation.
Insert the memory module vertically into the DIMM slot. Then push it in
until the golden finger on the memory module is deeply inserted in the
DIMM slot. The plastic clip at each side of the DIMM slot will automati-
cally close when the memory module is properly seated.
Manually check if the memory module has been locked in place by the
DIMM slot clips at the sides.
Important
You can barely see the golden finger if the memory module is properly in-
serted in the DIMM slot.
1.
2.
3.
Notch
Volt
DDR2
240-pin, 1�8V
64x2=128 pin 56x2=112 pin