Aspire Digital 8930 - Manual (Page 76)

70 Chapter 4
Index of Error Messages
Error Code List
Error Message List
Error Codes Error Messages
006 Equipment Configuration Error
Causes:
1. CPU BIOS Update Code Mismatch
2. IDE Primary Channel Master Drive Error
(THe causes will be shown before “Equipment
Configuration Error”)
010 Memory Error at xxxx:xxxx:xxxxh (R:xxxxh,
W:xxxxh)
070 Real Time Clock Error
071 CMOS Battery Bad
072 CMOS Checksum Error
110 System disabled.
Incorrect password is specified.
Battery critical LOW
In this situation BIOS will issue 4 short beeps
then shut down system, no message will show.
Thermal critical High
In this situation BIOS will shut down system,
not show message.
Error Messages FRU/Action in Sequence
Failure Fixed Disk Reconnect hard disk drive connector.
“Load Default Settings” in BIOS Setup Utility.
Hard disk drive
System board
Stuck Key see “Keyboard or Auxiliary Input Device
Check” on page 66.
Keyboard error see “Keyboard or Auxiliary Input Device
Check” on page 66.
Keyboard Controller Failed see “Keyboard or Auxiliary Input Device
Check” on page 66.
Keyboard locked - Unlock key switch Unlock external keyboard
Monitor type does not match CMOS - Run
Setup Run “Load Default Settings” in BIOS Setup
Utility.
Shadow RAM Failed at offset: nnnn BIOS ROM
System board
System RAM Failed at offset: nnnn DIMM
System board
Extended RAM Failed at offset: nnnn DIMM
System board