MSI Z68A-GD55 (G3) - Manual (Page 45)

BIOS Setup MS-7681
Chapter 3
3-7
BIOS Setup MS-7681
Chapter 3
IGD Mult-Montor
When “Enabled”, the ntegrated graphcs and extra graphcs card can be configured
as mult-montor mode.
USB Configuraton
Press to enter the sub-menu.
USB Devces:
It shows the type of nstalled USB devce.
USB Controller
Ths tem allows you to enable/ dsable the USB 2.0 controller.
Legacy USB Support
Select [Enabled] f you need to use a USB 2.0-nterfaced devce n the operatng
system.
Onboard USB 3.0 Controller
Ths tem allows you to enable/ dsable the USB 3.0 controller.
Super IO Configuraton
Press to enter the sub-menu.
Seral(COM) Port 0 Configuraton
Press to enter the sub-menu.
Seral (COM) Port0
Ths tem allows you to enable/ dsable the seral port.
Seral (COM) Port0 Settngs
Select an address and correspondng nterrupt for the seral port.
Hardware Montor
Press to enter the sub-menu.
CPU Smart Fan Target
The Smart Fan functon controls the CPU fan speed automatcally dependng on the
current temperature to keep t wth n a specfic range. You can enable a fan target
value here. If the current CPU fan temperature reaches to the target value, the smart
fan functon wll be actvated.
CPU/ System Temperature, CPU FAN/ SYS FAN 1/ 2 Speed
These tems show the current status of all of the montored hardware devces/
components such as CPU temperature/ system temperature and all fans’ speeds.
Power Management Setup
Press to enter the sub-menu.
EuP 2013
Ths tem s desgned for Energy Usng Products Lot 6 2013 (EuP) aka Energy
Related Products (ErP). To reduce Power Consumpton when system off or standby
mode.
Note: When “Enabled” EuP 2013 settng, system don’t support RTC wake up event
functon.
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶