MSI Z68A-GD80 (B3) Manual - Manual (Page 30)

2-14
Hardware Setup
Fan Power Connectors: CPUFAN1,SYSFAN1~4
The fan power connectors support system coolng fan wth +12V. When connectng the
wre to the connectors, always note that the red wre s the postve and should be con-
nected to the +12V; the black wre s Ground and should be connected to GND. If the
manboard has a System Hardware Montor chpset on-board, you must use a specally
desgned fan wth speed sensor to take advantage of the CPU fan control.
1.Gro
und
2.+1
2V
3.Se
nsor/
No U
se
1.Gro
und
2.+1
2V
3.Se
nsor
4.Co
ntrol
CPUFAN1 SYSFAN1~4
Important
Please refer to the recommended CPU fans at processor’s offical webste or consult
the vendors for proper CPU coolng fan.
CPUFAN1 support Smart fan control. You can nstall Control Center utlty that wll
automatcally control the CPUFAN1 speeds accordng to the actual CPUFAN1 tem-
peratures.
Fan cooler set wth 3 or 4 pns power connector are both avalable for CPUFAN1.
DLED3 Connector: JDLED3 (optonal)
Ths s reserved for connectng the MSI future control card.
10.N
o Pin
14.C
ontro
l pin
8.Co
ntrol
pin
12.C
ontro
l pin
6.Gro
und
4.Co
ntrol
pin
2.Co
ntrol
pin
1.5V
SB
3.Co
ntrol
pin
5.Co
ntrol
pin
7.Co
ntrol
pin
9.Gro
und
11.R
eserv
ed
pin
13.G
roun
d
•
•
•