Audiovox VE926 - Manual (Page 20)

19
* I
SETTING THE CABLE TV MODE
1) Press the SET button three times to enter the TV/Cable configuration mode.
2) CABLE or AIR will appear on the display.
3) Press the SEEK button to select Cable mode.
4) Press the CH UP/DOWN button(s) to select the desired cable mode (STD/IRC/HRC).
5) When the desired mode is reached, press the ON/OFF button to confirm.
SETTING THE AIR TV MODE
1) Press the SET button three times to enter the TV/Cable configuration mode.
2) Press the SEEK button to select the AIR mode.
3) Press the ON/OFF button to confirm.
SETTING THE SPEAKER MODE
1) With power off, press the SET button four times to enter the speaker configuration mode.
″ISP (or ESP) ″ appears on the VFD.
2) Press the seek button to toggle between the ″I SP″ and ″E SP″
3) When the desired mode is reached, press the ON/OFF button.
SETTING THE INTERCOM MODE
4) With power off, press the SET button five times to enter the intercom configuration mode.
″Int On (or Int OFF) ″ appears on the VFD.
5) Press the seek button to toggle between the ″Int On″ and ″Int OFF″
6) When the desired mode is reached, press the ON/OFF button.
nt OFF : default, No response to call signal.
SETTING THE PRESETS (IN AM, FM OR TV MODES)
1) Tune to the desired channel/station.
2) Press the SET button and the display flashes.
3) Press desired preset (P1, P2, P3 & P4) to confirm the selection.
NOTE: you can preset 4- AM, 4- FM and 4- TV Programs