MSI H97 GAMING 3 Manual - Manual (Page 71)

Chapter 3
3-12 BIOS Setup 3-13 BIOS Setup
▶Parallel (LPT) Port Settings [Auto]
Sets parallel port (LPT). If set to "Auto", BIOS will optimize the IRQ
automatically or you can set it manually.
▶Device Mode [Printer Mode]
Selects an operating mode for parallel port.
[Printer Mode] Printer port mode
[SPP] Standard Parallel Port mode
[EPP-1.9/ 1.7 + SPP] Enhanced Parallel Port-1.9/ 1.7 mode + Standard
Parallel Port mode.
[ECP] Extended Capability Port mode
[ECP + EPP-1.9/ 1.7] Extended Capability Port mode + Enhanced Parallel
Port-1.9/ 1.7 mode.
▶Intel(R) Smart Connect Configuration
Sets Intel Smart Connect Technology for optimizing system network performance in
sleep mode. Press to enter the sub-menu.
▶Intel(R) Smart Connect Technology [Enabled]
Enables or disables Intel(R) Smart Connect Technology. This feature can update
applications (ex. email and social networks) by periodically waking your system from
sleep mode. And you do not need to wait for the applications to update when you
wake up the system.
[Enabled] Enables Intel smart connect technology.
[Disabled] Disables Intel smart connect technology.
▶Power Management Setup
Sets system Power Management of EuP2013 and AC Power Loss behaviors. Press
to enter the sub-menu.
▶EuP 2013 [Disabled]
Enables or disables the system power consumption according to EuP2013 regula-
tion.
[Enabled] Optimize the system power consumption according to EuP 2013 reg-
ulation.
[Disabled] Disables this function.
Note: When enabled, the system will not support S4 & S5 wake up by USB, PCI and
PCIe devices.
▶Restore after AC Power Loss [Power Off]
Sets the system behaviors while encountering the AC power loss.
[Power Off] Leaves the system in power off state after restoring AC power.
[Power On] Boot up the system after restoring AC power.
[Last State] Restores the system to the previous state (power on/ power off)
before AC power loss.
▶On board Function LED Control [On]
Enables or disables the onboard function LEDs.
[On] Enables onboard function LEDs.
[Off] Disables onboard function LEDs.