EasyN NR-1-A4 Series - Manual (Page 36)

36
function is mainly used when there are not enough IP addresses to assign. Users can set one IP
address for the NVR, and set one IP address which is in the same network segment with the IP
cameras. Then users can set cameras’ IP addresses as they need unlimitedly without occupying
the limited IP used by other devices like PC or NVR.This function is extremely useful in large
network monitor project or install network monitor in the original network .)
As shown in Figure 39:
Figure 39
4. After checking “enable agents transmit”, IP Camera’s time verification, reboot and
setting are transmitted through NVR.
16、PTZ Control
Right click the IP camera you will control in “network navigator” --- right click