American Aimers VIIPRO Image Processor Headlight Aimer - Manual (Page 6)

STEP 1. TOOLS REQUIRED
• 3/8” Allen Wrench
• ½” Socket
• ½” Box-end Wrench
• Torpedo Level
When facing towards
the front of the “T” base
Front “T should be ex-
tending further to the left
side than right to allow for
center holes to align.
(Picture 1)
Step 2. BASE ASSEMBLY
On a flat surface, position the two base legs to form a “T” Install the Anti Rotate
Bracket between the Front and Rear Base as shown. (Picture 2) There are “This Side
Up Stickers” located on both of the Base Legs to aid you in proper positioning of the
bases. With center holes aligned, install 5 inch Hex Head Bolts so the Washer and
Lock Nut are on the
backside of the Rear
“T” Base. At this time,
tighten bolts to be
snug, while keeping
pieces flush with top
surfaces. Adjustment
will be made later, at
this section , to level
the Aim Head.
T-
B
as
e
Fr
on
t
Extends Further Left
Picture 1
T-Base Rear
5” Hex Head
Bolts
Note:
Large
Hole on
Top
Using two 5/16” x 1/2” Hex Head
Bolts place the Cam Block assembly
into the Base and tighten. (Picture 4-
1)
Cam Block
Assembly
5/16” x
1/2” Hex
Head
Bolts
Picture 4-1
Picture
4-2
Brass
Washer
3/8” x 1-3/4”
Shoulder Bolt
Using a 3/8” Shoulder Bolt, install the
Wheel to the Cam Block assembly as
shown. (Picture 4-2)
Step 4 CAM BLOCK ASSEMBLY
Step 3. WHEEL ASSEMBLY
Using 6-1/2” Hex Head Bolts,
install the wheels so that they are
on the front side of the Base.
A Jam Nut is installed on the
inside of the Base while a Lock
Nut is placed on the outside.
NOTE: Bolt should be locked in
place to allow Wheel to spin
freely (without excess play in the
Wheel). This can be accomplished by pushing the Bolt through the Wheel and into
Base hole. Place Jam Nut on inside and while pushing Bolt and Wheel against
Base, tighten Jam Nut to inner surface and then turn nut one extra turn. Tighten
Lock Nut to secure bolt. (Picture 3)
Lock
Nut
6-1/2” Hex Head Bolt
Jam Nut
Picture 3
Base Wheel
Anti-
Rotate
Bracket Picture 2
Washers
Lock-Nut
3/8” x 5”
Hex
Bolts
Vision II Pro
Optical Headlamp Aimer
Assembly Procedure 1.2. 1
Page 6 of 28
Picture
4-2
Brass
Washer
3/8” x 1-3/4”
Shoulder Bolt
Picture
4-2