DuraVent DirectVent Pro Chimney Liner System - Manual (Page 4)

4
Parts List
Number Description
46DVA-ADF Co-Linear FLex ConneCtors
46DVA-gk
(3")
46DVA-ct
(4")
DireCt Vent Chimney Liner
termination Kit (BasepLate & Co-
Linear to Co-axiaL aDapter)
46DVA-gcl
Co-axiaL to Co-Linear appLianCe
ConneCtor (stanDarD)
46DVA-tcl
Co-axiaL to Co-Linear appLianCe
ConneCtor (ConneCtor For traVis
inDustries)
46DVA-Vcl
Co-axiaL to Co-Linear appLianCe
ConneCtor (ConneCtor For Vermont
Castings)
46DVA-Vc VertiCaL termination Cap
46DVA-Vch VertiCaL termination Cap (high WinD)
2280 3" Chimney Liner pipe
790 3" FLex puLLer (rope not inCLuDeD)
INSTALLATION PRECAUTIONS
The DuraVent Direct Vent Chimney Liner
System is an engineered product that has
been designed and tested for use with an
approved list of direct vent gas appliances. The
DuraVent warranty will be voided, and serious
fire, health, or other safety hazazrds may result
from any of the following actions:
• Installation of any damaged Chimney Liner
System.
• Unauthorized modifications of the Chimney
Liner System.
• Installation of any component part not
manufactured or approved by DuraVent.
• Installation other than as instructed by
DuraVent and the appliance manufacturer.
Consult your local building codes before
beginning the installation.
WARNING
•Always maintain required clearances (air
spaces) to nearby combustibles to prevent a
fire hazard. Be sure to check the appliance
manufacturer’s installation instructions for
minimum clearance requirements between the
outer walls of the vent pipe/liner system and
nearby combustible surfaces. Be sure to check
the vent termination clearance requirements
from decks, windows, soffits, gas regulators,
and air supply inlets, as specified in local
building codes.
• The gas appliance and vent system must be
vented directly to the outside of the building,
and never be attached to a chimney serving a
separate solid fuel or gas-burning appliance.
Each direct vent gas appliance must use it’s
own separate vent system. Common vent
systems are prohibited.
SAFETY PRECAUTIONS FOR THE
INSTALLER
• Wear gloves and safety glasses for
protection.
• Exercise extreme caution when using
ladders or on roof tops.
• Be aware of electrical wiring locations in
walls and ceilings.
PARTS LIST
The DuraVent Direct Vent Chimney Liner
System offers a complete line of component
parts for installation. Please see our catalog
for details.
PLANNING YOUR INSTALLATION
The Direct Vent Chimney Liner System was
designed to be installed in an existing masonry
or zero clearance chimney, and connected
to either a stove, insert or other appropriate
direct vent gas appliance. (Figure 1). It is
important to carefully measure the length of
flex needed to reach from the appliance outlet
to the termination cap. If the flex length is too