Kramer Electronics 718 - Manual (Page 10)

717/718 - Connecting the 717 and 718 7
5 Connecting the 717 and 718
You can use the 717 and 718 to configure a long distance audio-video transmitter
and receiver system.
To connect the 717 and the 718 as illustrated in the example in Figure 4 :
1. On the 717, connect a composite video source (for example, a composite
video player) to the VIDEO IN BNC connector, and connect the unbalanced
stereo audio to the AUDIO IN LEFT and RIGHT AUDIO IN RCA connectors.
2. Using CAT 5 cabling, connect the LINE OUT RJ-45 connector on the 717 to
the RJ-45 LINE IN connector on the 718.
3. On the 718, connect the VIDEO OUT BNC connector to a composite video
acceptor (for example, a display), and connect the AUDIO OUT RIGHT and
LEFT RCA connectors to an unbalanced audio acceptor (for example, an
amplifier).
4. Important: You must connect a 12V DC power supply to each of the devices
in the following order:

First connect power to the 717
 Then connect power to the 718.
The 717 must be powered on first.
Note: The video and audio signals stabilize in a few seconds. If the picture
contains artifacts or does not appear at all, reconnect either end of the twisted pair
cable.
Note: The 717 and 718 do not have the Power Connect™ feature.