Alamo Machete 2 02986941C - Manual (Page 110)

MAINTENANCE
MACHETE 2 11/08 Maintenance Section 4-14
©2008 Alamo Group Inc.
MAINTENANCE
LUBRICATION
Grease each spindle with one pump of high quality lithium grease weekly. More than one pump is
unnecessary and will cause a mess when extra grease squirts out of the relief.
Grease fittings are on front of machine, just above the blades.
Belts:
Check the belt tension daily. Your buzzbar is equipped with high performance Micro-V belts that run much
tighter than regular V-belts. The belts should be tensioned to 15 to 20 lbs. of force for 5/16 of an inch of
deflection.
If belts begin to slip, check tension.
To tighten the belts, loosen the four nuts that hold the spindle to the body of the machine. Then use a hand
wrench or socket to turn the bolt that tensions the belt. Never use power tools to tighten belt. Once the belts
begin to tighten, small adjustments will produce large changes in belt tension.
Too much tension can cause premature bearing, sheave, and belt damage.