Kramer Electronics FC-14 User Manual
Page 9
Using Your RGBHV to Component Transcoder
7
5.4 Converting a VGA Source
You can convert and output a VGA signal (or SVGA, XGA, UXGA) to Y,
B-Y, R-Y, via a
FC-14 RGBHV to Component Transcoder, as the example in
Figure 5 illustrates, as follows:
1. Connect the VGA graphics source to the RGBHV DB15F input
connector.
2. Connect the Y, B-Y, and R-Y outputs to the plasma monitor.
3. Connect the 12V DC power adapter to the power socket and connect the
adapter to the mains electricity.
4. Press the RGsB input format selector.
The signal from the RGsB VGA graphics source converts and outputs to
the plasma monitor.
5. Switch on the power.
The Power switch illuminates.
Figure 5: Converting from a VGA Graphics Source to a Plasma Monitor