Kramer Electronics RC-54DL - Manual (Page 8)

6 RC-54DL - Connecting the RC-54DL KNET™ Auxiliary Control Panel
4 Connecting the RC-54DL KNET™ Auxiliary
Control Panel
Always switch off the power to each device before connecting it to your
Transmitter and Receiver pair. After connecting your Transmitter and Receiver
pair, connect their power and then switch on the power to each device.
To connect the RC-54DL, as shown in the example in Figure 3 , do the following:
1. Connect the K-NET ports to any RC devices with K-NET (for example, the
RC-63DL and SL-12).
2. Connect the 12V DC power adapter to the RC-54DL power socket and to the
mains electricity (not shown in Figure 3 ).
Alternatively, the RC-54DL can receive power over the K-NET port via the
connected master room controller.
Figure 3: Connecting the RC-54DL
!