Kramer Electronics FC-29 - Manual (Page 7)

Using the FC-29 IR Learner
5
5 Using the FC-29 IR Learner
This section describes how to connect the FC-29, learn and test the IR
commands written to the PC, save them and then export them as a driver file.
It is recommended to test each IR command directly after it is learned
5.1 Connecting the FC-29 and Learning the IR Commands
To connect the FC-29 IR Learner, as illustrated in the example in Figure 2:
1. Connect the FC-29 directly to your PC via the USB connector.
Be sure that the ON LED of the FC-29 lights.
Figure 2: Connecting the FC-29 IR Learner
2. Install the RC Configuration 2 software 1 .
3. Open the Kramer RC Configuration 2 program.
4. From the File menu, click Driver Manager.
The Driver Manager window appears.
5. Create a new vendor, device and revision if you want to keep the IR commands
in a separate driver file, or set to an existing vendor, device and revision if you
want new IR commands added to them.
6. Click the New button in the IR commands area to type the new command name.
The following window appears:
1 Download the Kramer RC-SV Configuration guide from the Internet at this URL: http://www.kramerelectronics.com