Kramer Electronics VP-729 - Manual (Page 48)

VP-729 - Audio Flash Memory Upgrade 43
43
9. Click Run.
After each stage of the operation is completed, the check-box for that stage
becomes colored green.
See also the blue progress indicator on the status bar
10. When the operation is completed, all 4 check-boxes will be colored green
and the status bar message: Memory Verify Pass appears:
If an error message: “Not Finished” shows, click Run again
Figure 31: Atmel – Flip Window (Operation Completed)
11. Close the “Atmel – Flip” window.
12. Disconnect the power on the VP-729.
13. If required, disconnect the rear panel AUDIO PROG. terminal block
connector on the VP-729.
14. Release the rear panel AUDIO PROG. button, using a small screwdriver.
15. Connect the power to the VP-729.
Upon initialization, the new VP-729 audio software version shows in the
Information menu (see Figure 22 ).