Kramer Electronics VP-729 - Manual (Page 14)

VP-729 - Connecting the VP-729 9
9
5 Connecting the VP-729
Always switch off the power to each device before connecting it to your
VP-729. After connecting your VP-729, connect its power and then
switch on the power to each device.
To connect the VP-729 as illustrated in the example in Figure 3 , do the following:
1. Connect the video sources:
 A component video source (for example, a DVD player) to the
UNIV. IN 1 RCA connectors, Y/CV, P
B /C and P R
Component video is sometimes called YUV, or Y, B-Y, R-Y
 An s-Video source (for example, a DVD player) to the UNIV. IN 4 RCA
connectors, Y/CV and P
B /C
 A computer graphics source to the UXGA 1 IN 15-pin HD computer
graphics video connector
 An HDMI source (for example, a DVD player) to the HDMI 1 IN connector
 A graphics data source (for example, JPEG files, that should be smaller
than 1MB and should not exceed a resolution of 2048x1536, from a PC
or a USB flash drive) to the USB connector on the front panel of the
machine
2. Connect the unbalanced stereo or digital audio sources:
 The audio of the component video source 1 to the AUDIO UNIV IN 1
S/PDIF RCA connector
 The audio of the s-Video source 4 to the AUDIO UNIV IN 4 L and R
RCA connector
 The audio of computer graphics source to the AUDIO UXGA 1 3.5mm
mini jack
Although this connecting example shows only several inputs that are connected,
you can connect all the inputs simultaneously
3. Connect the video outputs:
 The HDMI OUT connector to an HDMI acceptor (for example, a plasma
display)
i