Kramer Electronics VM-1H4C - Manual (Page 9)

6
VM-1H4C – Defining the VM-1H4C 1:4 HDMI Over CAT 5 DA
4 Defining the VM-1H4C 1:4 HDMI Over CAT 5
DA
The VM-1H4C encodes the HDMI, IR and RS-232 signals and transmits them over
TP cable to a compatible receiver (for example, the Kramer TP-574 HDMI/RS-232/
IR Line Receiver).
Figure 1 defines the front and rear panels of the VM-1H4C.
Figure 1: VM-1H4C 1:4 HDMI Over CAT 5 DA Front and Rear Panels
# Feature Function
1 POWER LED Lights green when the unit receives power
2 REMOTE IR 3.5mm Mini Jack Connect to the remote IR emitter or receiver
3 INPUT LED Lights green when the input receives a signal. Flashes when
connected but there is no active signal
4
EDID
READ Button Press to capture the EDID from the active output, (see
Section 6 )
5 SELECT Button Press to select the output from which to capture the EDID
6 OUTPUT 1~4 LEDs The relevant LED lights green when that output is connected
7 INPUT HDMI Connector Connect to the HDMI source
8 RS-232 9-pin D-sub
Connector Connect to an RS-232 controller, (see Section 5.1 )
9 OUT 1 ~ 4 TP Output
RJ-45
Connectors Connect to the LINE IN RJ-45 connector on the TP receivers,
for example, TP-574, (see
Section 7 )
10 12V DC Power Connector Connect to the +12V DC power adapter. Center pin positive