Kramer Electronics VP-6A - Manual (Page 5)

Overview
3
3 Overview
The Kramer VP-6A is a high performance distribution amplifier for computer
graphics (UXGA) video and audio signals. The VP-6A accepts:
One computer graphics input: provides correct buffering and isolation,
and distributes the signal to six outputs on 15-pin HD connectors, and one
twisted pair output
A stereo audio input signal: either 1 an unbalanced stereo audio input
signal on a 3.5mm mini jack, or a balanced stereo audio input signal on a
5-pin terminal block connector. The VP-6A outputs 12 stereo audio
signals simultaneously: six unbalanced stereo audio signals on 3.5mm
mini jacks, and six balanced stereo audio signals on 5-pin terminal block
connectors. If the selected audio input is unbalanced, it is converted to
balanced stereo audio; if the selected audio input is balanced, it is
converted to unbalanced stereo audio
The VP-6A can:
Power the receiver over the same CAT5 cable
Be used with the
TP-122 XGA / Audio Line Receiver (converting the
CAT5 signal to XGA, stereo analog and S/PDIF digital audio outputs) or
with the TP-120 XGA Line Receiver (converting the CAT5 signal to an
XGA output)
In addition, the VP-6A features:
A video bandwidth of 500MHz that ensures transparent operation at all
graphics resolutions
Switches on the underside for ID Bit control and sync polarity
Front panel controls for UXGA equalization, as well as left and right
audio level controls
A transmission range of more than 300 ft. (more than 100 meters) over
UTP cabling
1 Selected via a pushbutton