Kramer Electronics VM-4HN - Manual (Page 10)

VM-4HN - Connecting the VM-4HN 7
Figure 2: Connecting the VM-4HN 1:4 HDMI DA
4.1 Acquiring an EDID
To acquire an EDID, press the EDID SETUP button as follows:
1. The first press of the EDID SETUP button displays the present EDID status
similar to that shown in the next step.
2. The second press of EDID SETUP enters the read mode and each
additional press cycles through the source options:
OUT 1 -> OUT 2 -> OUT 3 -> OUT 4 -> all LEDS flash slowly for auto-mix ->
all LEDs flash quickly for a default EDID.
3. When the desired EDID source is reached, release the EDID SETUP button.
The VM-4HN reads the EDID for a few seconds. When finished, all LEDS
return to display the present output connection status.
If an unconnected output is chosen or the EDID cannot be read, the VM-4HN loads the
default EDID.