Kramer Electronics VM-4HDCPxl - Manual (Page 11)

Acquiring the EDID
9
9
While the EDID is being copied, the EDID SELECT and READ buttons
illuminate.
The new EDID is copied when both buttons no longer illuminate.
7.2 Acquiring the Default EDID
To reset to the default EDID, do the following:
1. Turn on the VM-4HDCPxl.
2. Press the EDID SELECT button and set it to the DEFAULT EDID mode.
All the OUTPUT STATUS LEDs flash simultaneously.
3. Press the EDID READ button to copy the default EDID to the input 2 .
While the EDID is being copied, the EDID SELECT and READ buttons
illuminate. The new EDID is copied when both buttons no longer
illuminate.
7.3 Acquiring the Auto-mix EDID from the Connected Outputs
To acquire the Auto-mix EDID:
1. Turn on the VM-4HDCPxl.
2. Connect the desired output display devices.
3. Enter the AUTO-MIX mode as shown in
Figure 3 .
The OUTPUT STATUS LEDs illuminate.
4. Press the READ button to copy the EDID of the selected OUTPUT to the
input 2 .
While the EDID is being copied, the EDID SELECT and READ buttons
illuminate. The new EDID is copied when both buttons no longer
illuminate.
7.4 Connecting a PC to the RS-232 Port for Programming
The RS-232 port is used for service.
This procedure should be performed by qualified personnel only.
To use the RS-232 port for programming
1
1. Turn off the power and disconnect the power cord from the VM-4HDCPxl
and then open the cover.
:
2. Locate the 3-pin jumper on the board 2
1 For firmware upgrade procedure go to our Web site at http://www.kramerelectronics.com
.
2 Connecting the middle pin and one of the side pins