Kramer Electronics VM-4HDCPxl - Manual (Page 10)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Acquiring the EDID
8
7 Acquiring the EDID
You can acquire the EDID from:
•
One output (the selected output LED flashes), see section 7.1
• The default EDID (all the output LEDs flash), see section 7.2
• Several connected outputs, the auto-mix mode 1
7.3
(the output LEDs
illuminate), see section
To cycle between the different modes, press the EDID SELECT button as
shown in Figure 3.
Figure 3: EDID Modes
7.1 Acquiring/Changing the EDID from One Output
To acquire or change the EDID of one new output display:
1. Turn on the VM-4HDCPxl.
2. Connect the new output display device.
3. Press the EDID SELECT button to enter the ONE OUTPUT mode as
shown in Figure 3 .
4. Press EDID SELECT as needed to select the desired output.
The appropriate OUTPUT STATUS LED flashes indicating that that output
channel is selected.
5. Press the EDID READ button to copy the EDID of the selected OUTPUT
to the input 2
1 The EDID acquired is a weighted average of all the connected outputs. For example, if several displays with different
resolutions are connected to the outputs, the acquired EDID supports all the resolutions, as well as other parameters included
in the EDID
.
2 If you want to cancel the EDID modification, wait for a few seconds without touching any button