Kramer Electronics VM-400HDCP - Manual (Page 8)

VM-400HDCP - Defining the VM-400HDCP 1:4 DVI Distributor 5
5
4 Defining the VM-400HDCP 1:4 DVI
Distributor
Figure 1 defines the front panel of the VM-400HDCP.
Figure 1: VM-400HDCP 1:4 DVI Distributor Front Panel
# Feature Function
1 INPUT DVI Connector Connect to a DVI source
2 MONITOR OUT DVI
Loop Connector
Connect to a DVI acceptor for input monitoring
3
EDID
READ Button Press to acquire the EDID following selecting the EDID
source. Press again to indicate the EDID status (see
Section 6
Lights when configuring the EDID
)
4 SELECT Button Press to select the EDID source (single output, Auto-Mix or
default), see Section 6
Lights when configuring the EDID
5 MONITOR LED Lights green when an output is connected to the Monitor
Out connector and is active.
The LED flashes to indicate the source of the EDID
acquired (see Section 6
6
) or when connecting a non HDCP
display while providing HDCP content to the VM-400HDCP
OUT1, OUT 2, OUT 3
LEDs
Lights green when an output is connected and is active.
The LED flashes to indicate the source of the EDID
acquired (see Section 6
7
) or when connecting a non HDCP
display while providing HDCP content to the VM-400HDCP
ON LED Lights green when the device receives power