Kramer Electronics VM-400HDCP - Manual (Page 12)

VM-400HDCP - Acquiring the EDID 9
9
To acquire the EDID from Output 3:
1. Press the EDID SELECT button repeatedly until OUTPUT 3 LED flashes.
2. Press and hold the EDID READ button until the LED stops flashing.
The EDID from Output 3 is now stored at the input.
Pressing the EDID SELECT button briefly once causes the relevant LEDs to
indicate which EDID is stored at the input as follows:
 The MONITOR LED flashes—the EDID from MONITOR was the last
acquired
 OUTPUT 1 LED flashes—the EDID from OUTPUT 1 was the last
acquired
 OUTPUT 2 LED flashes—the EDID from OUTPUT 2 was the last
acquired, and so on
 All OUTPUT LEDs flash—the default EDID was the last acquired
 All OUTPUT LEDs light—the Auto-Mix EDID was the last acquired
The EDID acquired is a weighted average of all the connected outputs. For
example, if several displays with different resolutions are connected to the
outputs, the acquired EDID supports all the resolutions, as well as other
parameters included in the EDID.