5 connecting the vm-22hd 2 x 1:2 hd/sd-sdi da, 1 connecting the vm-22hd in the single link mode, Connecting the vm-22hd 2 x 1:2 hd/sd-sdi da – Kramer Electronics VM-22HD User Manual
Page 7: Connecting the vm-22hd in the single link mode

Connecting the VM-22HD 2 x 1:2 HD/SD-SDI DA
5
5 Connecting the VM-22HD 2 x 1:2 HD/SD-SDI DA
This section describes how to connect the VM-22HD in single link mode
(see section
) and in dual link mode (see section
).
5.1
Connecting the VM-22HD in the Single Link Mode
To connect the VM-22HD, as shown in the example in
, do the
following
1. Connect one or two HD-SDI/SD-SDI video sources (for example, cameras)
to the INPUT A and/or B BNC connectors.
2. Connect
up
to
four video OUTPUT BNC connectors to the appropriate
HD-SDI/SD-SDI video acceptors (for example, displays).
3. Connect the 12V DC power adapter to the power socket and connect the
adapter to the mains electricity (not shown in
).
The VM-22HD operates as soon as it is connected and powered on.
Figure 2: Connecting the VM-22HD in Single Link Mode
1 Switch OFF the power on each device before connecting it to your VM-22HD. After connecting your VM-22HD, switch on
its power and then switch on the power on each device
2 You do not have to connect all outputs