Kramer Electronics VM-5ARII - Manual (Page 16)

VM-5ARII, VM-20ARII - Connecting the Distribution Amplifiers 13
3. Connect the VIDEO OUT 1 to 20 BNC connectors to up to 20 acceptors (for
example, composite video recorders).
You are not required to connect all the acceptors.
4. Connect the AUDIO OUT 1 and 20 RCA connectors to up to 20 acceptors
(for example, the audio input on the video recorders).
You are not required to connect all the acceptors.
5. If needed, connect the VIDEO LOOP BNC connector to an acceptor (for
example, a composite video display or another VM-20ARII) and set the
termination pushbutton to 75Ω.
6. Connect the power cord to the unit (not shown in the illustration) and then to
the mains electricity. Switch on the power.
Use the power cord supplied with the unit.
7. If needed, adjust the VIDEO GAIN or EQ controls or the AUDIO GAIN on the
front panel.
8. Set the mode of operation by pressing one of the operating mode control
switches (one set for audio and one set for video) as follows:
ƒ Press the 1:20 switch to split input “1” to all 20 outputs
ƒ Press the 2x1:10 switch to split input "1" to outputs "1-10" and input "3"
to outputs "11-20"
ƒ Press the 4x1:5 switch to split four inputs to four consecutive sets of
five outputs each
ƒ Press the 1:10+2x1:5 switch to split input "1" to outputs "1-10", input
"3" to outputs "11-15" and input "4" to outputs "16-20"