Kramer Electronics VM-1110xl - Manual (Page 9)

Connecting Your VM-1110xl
7
6.1 Connecting a 1:10 Mono DA
To connect 1 the VM-1110xl as a 1:10 mono DA, as the example in Figure 2
illustrates, do the following:
1. Connect one mono audio source (for example, a mono audio player) to
INPUT A on the rear panel.
2. Connect up to 10 audio acceptors 2 to the OUT connectors on the rear panel.
3. On the front panel, release the 1:10 / 2x1:5 button.
4. Connect the power cord to the electricity supply.
5. Switch on the
VM-1110xl.
The audio input is distributed to the audio outputs.
Figure 2: Connecting the VM-1110xl as a 1:10 Mono DA
1 Switch OFF the power on each device before connecting it to your VM-1110xl. After connecting your VM-1110xl, switch on
its power and then switch on the power on each device
2 Not all outputs have to be connected