Kramer Electronics VM-1110xl - Manual (Page 11)

Connecting Your VM-1110xl
9
6.3 Connecting a 1:5 Stereo DA
To connect 1 the VM-1110xl as a 1:5 stereo DA, as the example in Figure 4
illustrates, do the following:
1. Connect one stereo audio source (for example, a stereo audio player) to
INPUT A (left channel) and INPUT B (right channel) on the rear panel.
2. Connect up to 5 audio acceptors 2 to the OUT connectors (left channels to
OUT A and right channels to OUT B) on the rear panel.
3. On the front panel, press IN the 1:10 / 2x1:5 button.
4. Connect the power cord to the electricity supply.
5. Switch on the
VM-1110xl.
The audio input is distributed to the audio outputs.
Figure 4: Connecting the VM-1110xl as a 1:5 Stereo DA
1 Switch OFF the power on each device before connecting it to your VM-1110xl. After connecting your VM-1110xl, switch on
its power and then switch on the power on each device. Not all outputs need to be connected