ADIC DS9000 Series - Manual (Page 31)

Operation and Maintenance 19
LCD Messages (DS9400D/L, DS9700D and DS9800D)
The following table describes the messages displayed on the LCD during and immediately after the POST:
Drive State LCD Message
1. POST is executing.
Will be displayed for 3 to 5 seconds, followed by:
“DRV F/W” is the firmware version of the drive.
“LCD F/W” is the firmware version of the LCD controller.
“ID” is the SCSI ID setting of the drive.
“CPH” is the cumulative power on hours of the drive.
“TSL” is the time since last cleaning cycle of the drive (will reset
to zero after every cleaning cycle if followed by a power recycle).
“DCL” is the drive data cartridge load counter.
2. POST completed, no cartridge
is present, and the handle is
down.
Note
This is the preferred state
for the DS9000 when
powering up.
3. POST completed, a cartridge
is present, but the handle is up
(not recommended).
Note
The DS9000 should not
be left in this state when
powering down.
This message will appear after approximately 5 minutes.
4. The drive detects an error
condition.
POST completes in about 13 seconds and the drive responds normally to all commands. However, it may take longer
for the media to become ready.