On off, Adjustable stop (s) (setting "5"), Q) nylon wing nut – Agri-Fab 45-0364 User Manual
Page 7
7
24. Position the flow control mounting bracket (figure 12).
a. Push on flow control arm until it locks in "OFF"
position.
b. Slide flow control mounting bracket along tube until
closure plate in bottom of hopper just closes.
c. Snug the 5/16" lock nuts just enough to hold flow
control mounting bracket in place.
d. Set adjustable stop at "5". Pull flow control arm
against stop. Verify that closure plate has opened
about half way.
e. If closure plate does not open half way, adjust
position of flow control mounting bracket until
closure plate will open about half way at "5" and
will still close when arm is locked in "OFF" position.
Tighten the 5/16" lock nuts.
FIGuRE 12
27. For most vehicles, assemble the hitch extension bracket
to the holes in the hitch tube shown at the
top of figure
14. Use two 1/4" x 1-3/4" hex bolts (B) and 1/4" hex lock
nuts (F) tightened only finger tight. Attach the spreader
hitch to your vehicle hitch. Check for interference with
the spreader directly behind and out to both sides of
the vehicle. Lift the spreader at each position to make
sure there is no interference with the spreader's flow
control. If there is interference with the rear of the vehicle,
assemble the hitch extension bracket as shown at the
bottom of figure
14.
Tighten the bolts and nuts when finished.
FIGuRE 11
FLOW
CONTROL
ARM
OFF
ON
1
2
3
4
6
7
8
9
10
5
ADJUSTABLE
STOP (S)
(SETTING "5")
ON
OFF
(Q) NYLON
WING NUT
OFF
ON
1
2
3
4
6
7
8
9
10
5
(J) 5/16" FLAT
WASHER
(I) NYLON
WASHER
(R) ADJUSTABLE
STOP
(E) 1/4" x 3/4"
CARRIAGE BOLT
FIGuRE 14
25. Assemble the hitch bracket to the hitch extension bracket
using two 3/8" x 3/4" hex bolts (C) and 3/8" hex lock nuts
(H). Insert the bolts from the bottom. See figure 13.
26. Assemble the hitch pin (O) through the hitch bracket
and the hitch extension bracket and secure with the
hair cotter pin (N). See figure 13.
(F) 1/4" HEX
LOCK NUT
(B) 1/4" x 1-3/4"
HEX BOLT
FIGuRE 13
(C) 3/8" x 3/4"
HEX BOLT
(H) 3/8" HEX
LOCK NUT
(O) HITCH PIN
(N) 1/8" HAIR
COTTER PIN