Agri-Fab 45-0364 - Manual (Page 6)

6
22. Place a 5/16" flat washer (J) onto the other end of the
flow control rod. Insert the end of the rod through the
curved slot in the flow control mounting bracket and
through the hole in the flow control link. Secure with a
5/16" flat washer (J) and a 3/32" x 3/4" cotter pin (L).
See figure 10.
NOTE: You can leave off the second washer if there is not
enough room on the end of the rod.
21. Hook the double bent end of the flow control rod through
the hole in the slide gate bracket located near the bottom
of the hopper. See figure 9.
FIGuRE 9
FIGuRE 8
20. Assemble the flow control arm to the flow control
mounting bracket using a 1/4" x 3/4" hex bolt (D), two
nylon washers (I) and a 1/4" hex lock nut (F).
Tighten
carefully. The flow control arm should be snug but
should pivot with no more than slight resistance. See
figure 8.
18. Assemble the vinyl grip (T) onto the flow control arm.
See figure 7.
19. Insert the flow control arm down through the slot in the
flow control bracket. Assemble the small hole of the flow
control link (U) to the flow control arm using a 1/4" x 1"
hex bolt (D), a nylon washer (I) and a 1/4" hex lock nut
(F) as shown in figure 7.
Tighten carefully. The flow
control link should be snug but should pivot with no
more than slight resistance.
23. Place the adjustable stop (R) into the "ON" end of the slot
in the top of the flow control mounting bracket. Secure
with the 1/4" x 3/4" carriage bolt (E), a nylon washer (I),
a 5/16" flat washer (J) and the nylon wing nut (Q). See
figure 11.
FIGuRE 10
FIGuRE 7
(B) 1/4" x 1"
HEX BOLT
(F) 1/4" HEX
LOCK NUT
OFF
ON
1
2
3
4
6
7
8
9
10
5
(U) FLOW
CONTROL
LINK
(small hole)
(I) NYLON
WASHER
(T) VINYL GRIP
OFF
ON
1
2
3
4
6
7
8
9
10
5
(B) 1/4" x 3/4"
HEX BOLT
(F) 1/4" HEX
LOCK NUT
(I) NYLON
WASHERS (2)
FLOW
CONTROL
ROD
OFF
ON
1
2
3
4
6
7
8
9
10
5
(J) 5/16"
FLAT
WASHER
(L) 3/32"
COTTER PIN
(J) 5/16"
FLAT
WASHER