DOCTER DOCTER®sight III User Manual
Page 17
Ex factory, the sight devices are delivered with MODE 2 (Dynamic). The
characteristic curve can be changed using the covering cap in which a magnet is
being integrated.
Changing the Operating Mode (MODE)
For that purpose, the magnet area (6) at the left side of the covering cap is to be
attached quickly to the horseshoe magnet symbol (7) at the device and, after 3
seconds, is to be taken off quickly.
When the signal has been detected, the mode LED (5) shows the new state a
moment later. This type of switching offers a high degree of protection against an
erroneous switching due to the uncontrolled effect of a magnetic field.
There is always switched upward by one mode and, from mode 3, back to the
mode 1. The set operating mode is saved and is immediately available after
switching-on.