DOCTER DOCTER®sight III - Manual (Page 14)

Mounting
Due to multitude of different adapter plates, the DOCTERsight can be mounted to
nearly all gun types without any problems. Your gunsmith will choose a convenient
mounting according to your requirement and to the gun type.
Independently of the used mounting type, the upper side of the adapter plate has 4
precision positioning pins. The sealing foil included in the delivery extend has to be
pasted onto the adapter plate. For that purpose, pull off the covering layer and paste
the seal onto the adapter plate where you have to consider the prepunched holes.
The DOCTERsight is water-tight only if the sealing foil has been applied properly.
Put the DOCTERsight onto the mounting plate where you have to consider the
fastening threads and the positioning pins. Then, fasten the device using the
delivered countersunk screws.
The combination of screw fastening and precision positioning pins prevents the hit
point position from shifting during the use.
Shooting Adjustment
Ex factory, the optical system of the DOCTERsight III is parallax-freely adjusted to a
distance of 40 m. You have to choose a shooting adjustment distance that meets
your requirements to the DOCTERsight III.
The DOCTERsight III has an elevation adjustment element (1) and a windage
adjustment element (2) that are separate from each other. These elements are
arranged at the top or at the right side of the device and are marked with rotation
direction arrows.
You will make the adjustment through of the slotted screws using the delivered scale
wheel and the delivered screwdriver (0.4 x 2.0).
Attention: Prior to each adjustment, the locking screws (3) have to be
loosened.
The elevation adjustment and the windage adjustment can be made independently of
each other. The available adjusting range allows the compensation of inaccuracies
on mounting as well as a ballistics correction. The windage adjustment has end stops
in both directions.
In case of the elevation adjustment, there has to be considered that the end stop in
downward direction is present in the mounted state only.
Please consider that the adjustments are clamped if there has been screwed up to
the end stop in the respective different adjusting direction.