SawStop Front Dust Shroud Replacement - Manual (Page 2)

Item Description Part number Qty
A Left Dust Shroud Half CB110 005 1
B Blast Shield CB110 007 1
C Right Dust Shroud Half CB110 006 1
D M5x2.2x20 Button Head Phillips Screw CB110 008 2
11.
Re-install the two socket head cap bolts which you
removed earlier to attach the dust shroud assembly
to the trunnion brace, but do not tighten the bolts.
You may find it easier to install the bolt on the right
by opening the motor cover to access the saw from
the side. If the dust shroud is black, slide the assem-
bly to the right so that the right dust shroud half lies
against the right side of the cast iron trunnion brace.
If the dust shroud is light gray, slide the assembly
to the left as far as possible. Tighten the two socket
head cap bolts with a 5 mm hex key.
10.
Turn the elevation handwheel to lower the arbor all
the way down.
12.
Turn the elevation handwheel to fully raise the arbor and re-install the blade. The arbor must be
raised when installing a blade with the new dust shroud installed. Close the dust shroud door and
re-install the table insert and blade guard.
8.
Carefully lower the arbor a bit by turning the eleva-
tion handwheel two complete turns.
9.
Now lower the dust shroud assembly into the saw
until it rests on the cast iron trunnion brace and the
oval holes in the left and right dust shroud halves
align with the threaded holes in the trunnion brace.
7.
The screw bosses at the front of the left and right
dust shroud halves will be aligned when the two dust
shroud halves are fitted together properly. Install the
two button head Phillip screws D in the bosses at the
front of the shroud, inserting them from right to left,
as shown, and tightening them with a Phillips screw-
driver. It may be easier to install the bottom screw
first. Do not over-tighten the screws.
6.
Position the blast shield B in the upper portion of the
left dust shroud half A so that the notch at the top of
the left edge of the blast shield aligns with the corre-
sponding protrusion in the left dust shroud half, and
the bottom of the blast shield sits on the ridge in the
left dust shroud half, as shown. Place the right dust
shroud half C along the right side of the blast shield
so that the notch on the right side of the blast shield
aligns with the corresponding protrusion in the right
dust shroud half.
SawStop Service Department
503-582-9934 www.sawstop.com
C
D
B
A
B
ridge
notch
A
socket head
cap bolts
cast iron trunnion brace
oval hole
A
B
C
oval hole
cast iron
trunnion
brace
C
notch
B
To achieve the improved dust collection, you must
connect a dust collection system to the rear port
on the saw as described in your owner’s manual.