Silverline 500W Hammer Drill - Manual (Page 5)

4
GB
Don’t force, or attempt to use a tool for a purpose it was not •
designed.
This tool is not intended for industrial use.
•
Wear suitable clothing and footwear
Don’t wear loose fitting clothing, neckties, jewellery, or other •
items which may become caught. Wear non slip footwear, or
footwear with protective toe caps where appropriate. Long hair
should be covered or tied back.
Keep your balance
Don’t over reach, keep proper footing at all times, do not use •
tools when standing on an unstable surface.
Accessories
The use of any attachment or accessory other than those •
mentioned in this manual could result in damage or injury. The
use of improper accessories could be dangerous, and may
invalidate your warranty.
Secure work
Where possible, always secure work. If appropriate use a •
clamp or vice, it will allow you to use both hands to operate
your tool.
Check for damaged or missing parts
Before each use, check if any part of the tool is damaged •
or missing, check carefully that it will operate properly and
perform its intended function. Check alignment of moving
parts for binding. Any guard or other part that is damaged
should be immediately repaired or replaced by an authorised
service centre.
DO NOT USE IF DEFECTIVE.
Mains Electrical Tool Safety
• The wires in this product are coloured:
Blue
Neutral (N)
Brown Live (L)
Green & Yellow Earth (E)
• As the colours may not correspond with the coloured markings
in your plug, proceed as follows.
• The wire which is coloured blue must be connected to the
terminal which is marked with the letter N or coloured black,
the wire which is coloured brown must be connected to the
terminal which is marked L or coloured red.
• This appliance must be protected by a suitable fuse.
• To prevent fire or shock hazard, do not expose this product to
rain/water or moisture.
• There are no user serviceable parts inside except those
General Safety Instructions
Carefully read and understand this manual and any label
attached to the tool before use. Keep these instructions with the
product for future reference. Ensure all persons who use this
product are fully acquainted with this manual.
Even when used as prescribed it is not possible to eliminate all
residual risk factors. Use with caution. If you are at all unsure
of the correct and safe manner in which to use this tool, do not
attempt to use it.
Remove adjusting keys
Always check to see that keys and adjusting devices are •
removed from the tool before use.
Clean the work area
Accidents can occur where benches and work areas are •
cluttered or dirty, floors must be kept clear, avoid working
where the floor is slippery. If working outdoors, make yourself
aware of all potential slip and trip hazards before using this
tool.
Children and pets
Children and pets should always be kept at a safe distance •
from your work area. Lock tools away where children can’t get
access to them. Do not allow children, or untrained persons to
use this tool.
Use the correct tool
Explanation of Symbols
• Wear eye protection
• Wear hearing protection
• Wear gloves
• Do not dispose of WEEE (Waste Electrical
and Electronic Equipment) as unsorted waste
• Class II construction (Double insulated)
• Wear breathing protection
Specification
Voltage .................................................230V
Frequency ............................................50Hz
Power ...................................................500W
No load speed ......................................0-2800RPM
Max drilling capacity
- Concrete ........................................16mm
- Wood .............................................25mm
- Steel ..............................................13mm
Weighted vibration ...............................9.81m/s 2
Sound pressure ....................................88dB(A)
Sound power ........................................99dB(A)
Double insulated ..................................
As part of our ongoing product development, specifications
of Silverline products may alter without notice.
265897_manual.indd 4 22/12/09 09:37:21