Silverline Jump Starter Air Compressor & Inverter - Manual (Page 9)

88
GB GB
Maintenance
Fuses
• A 15A blade type fuse is fitted into the front and rear of the jump starter.
The front fuse protects the circuits that power the lights, 12V sockets and
compressor. The rear fuse protects the circuit that powers the inverter
• To replace either fuse, move all switches (1)+(2)+(3)+(5)+(13) to the
‘OFF’ position, and remove the fuse. Replace with another 15A fuse of
the same type
• Determine the source of the overload or short, and remove before
switching power back on. If the fuse keeps blowing it indicates a fault
condition with the unit
Cleaning
• Keep your jump starter clean. Always clean dust / particles away, and
never allow ventilation holes to become blocked. Use a soft brush, or dry
cloth to clean the machine, if available blow through the ventilation holes
with clean, dry, compressed air.
• Make sure that the positive and negative lead clamps are kept clean.
Dirty electrical contacts will severely impair the performance of this
product.
Disposal
Warning: This product incorporates a sealed VRLA (Valve Regulated Lead
Acid) battery. Before disposal, remove the battery from the product and
take to a facility in your region that disposes of lead acid batteries. Do not
dispose of the product with the battery still fitted
To remove the battery for disposal or replacement, remove the clamps
from their stored positions and place them at the side of the jump starter.
Remove the 8 recessed screws from the back panel and gently pull apart
the front half and rear half of the casing to gain access to the battery.
Carefully remove the battery.
• Do not dispose of power tools, or other waste electrical and electronic
equipment, with household waste.
• Contact your local waste disposal authority for information on the proper
way to dispose of tools.
345782_Z1MANPRO1.indd 8 25/01/2013 15:20