Rivera Primo Brute IV Extreme for 1990-05 Dyna Models - Manual (Page 6)

STEP 20
Installing the outer belt guard together with its
stylish derby cover is next. (Prior to installing the
outer guard, install the oil filter if purchased sep-
arately). Position the guard up against the stand-
offs making sure that the shifter shaft support is
aligned with the hole and then check to make
certain all mounting holes properly line-up and
that the guard sits squarely up against the stand-
offs.
STEP 21
Coat the threads of the mounting bolts with
2 drops of Blue threadlock and tighten the
bolts with your Allen driver. Continue the
mating process by fastening all 4 bolts until
they have seated within the countersunk
holes in the outer guard.
STEP 18
At this time, adjust the Pro-Clutch ac-
cording to specifications. Re-check
until you are satisfied (see last page
for adjustment specs).
Finally, bend the lock tabs over against
a flat on the nuts. This will prevent the
nuts from coming loose.
STEP 17
There are 3 mounting bolts used to attach
the nose cover. Coat each with 2 drops of
Blue threadlock and torque until secure.
STEP 19
Assemble the 4 stand-offs to the motor plate. These pieces will act
as the support for the outer guard. Begin by thread¬ing in each
stud into each stand-off using 3 drops of Red loctite.Thread them
into the stand-offs until they bottom (should be left with 3/4” ex-
posed). Now apply 3 drops of Red thread locker on the exposed
stud and thread each stand-off into a counterbored & threaded
hole on the motor plate. Tighten until they bottom-out on the plate.