Australian Monitor PM16 User Manual
Page 6
PAGE 6
AMPRO PM12 & PM16 INSTALLATION & OPERATION MANUAL
MONO INPUT CHANNEL SECTION
FREQUENCY + MID
Mid frequency adjustment. A ‘bell response’ adjustment that allows you to select the mid frequency, variable between 250Hz and 6kHz
and to then vary the response ±15dB on either side of the selected frequency, with a fixed Q of 1.5Q (bandwidth).
LOW
Controls the low frequency response of each channel. Provides ±15dB at 80Hz.
AUX 1
This send is taken after the EQ section and pre fader (PRE-FADER, POST-EQ), and is therefore unaffected by the fader position.This is
particularly suitable for foldback or monitor feeds, which need to be controlled separately from the main PA Mix.
AUX 2
This send is derived after the EQ and post fader (POST FADER, POST EQ), and therefore follows any changers in fader level. This send
is normally used to drive effects processing units which are fed back into the mixer and which must track the channel fader.
PAN
Post fader and routes signal proportionally to the left and right outputs.
MUTE
Press to mute the channel.
CHANNEL FADER
Adjusts the level of the signal for the main left/right mix. Normal operating position is at the “O” mark.
SIGNAL PRESENCE METER
4 LEDs indicate signal level at the insert return point, pre-fader.
PFL
Monitor the channel with the PFL button. When the PFL switch is depressed, the adjacent LED will illuminate indicating PFL is active.
The signal is routed to both the main signal presence meters and the headphone output, allowing both visual and audible monitoring of
the signal.
9
10
11
12
13
14
15
16
17
9
10
11
12
13
14
15
16
17