Australian Monitor AMIS31EQ - Manual (Page 9)

9
3. Set all slider controls to the centre detent 0dB position.
4. Set the range switch to the 6dB position (green LED illuminated).
5. Apply signal to the audio system.
6. Release the bypass switch (red LED off)
7. If the overload LED illuminates you may need to turn the level control
down until the LED flashes occasionally or is off.
8. Equalize your audio system as desired.
9. If there is not enough adjustment available to achieve the equalization
required, you may need to go back to step 2 & repeat the
equalization process with the range switch in the 12dB position (yellow
LED illuminated).
AMIS215EQ/AMIS31EQ Specifications
1. Equalizer
Bands;
AMIS215EQ; 2 x 15 2/3 Octave ISO Spacing from 20Hz –
20kHz
AMIS31EQ; 31 1/3 Octave ISO Spacing from 20Hz - 20kHz
Type; Constant Q
Accuracy; 3% Centre Frequency
Travel; 20mm Positive Centre Detent
Range; +/- 6dB or +/- 12dB selectable
2. Inputs
Type; Active balanced/unbalanced
Connectors; 3 pin XLR, 6.35mm TRS balanced, RCA
unbalanced
Impedance; 20k Ohms balanced, 15k Ohms unbalanced
Max level; +22dBm (level control at centre)