Australian Monitor IS600 - Manual (Page 7)

PAG E 7
B I N D I N G P O S T O U T P U T S
When terminating to the 4 mm binding post (banana jack) output
connectors, banana plugs or bare wires can be used. The red terminal
is positive and the black terminal is negative (ground).
S P E A K E R O U T P U T S
When using the 4 pole speaker connector for speaker output, use only
the mating 4 pole in-line connector. This connector is designed so that
both speakers can be fed from a single connector. Two speaker
connectors are provided on the amplifier. The "Channel A" speaker
connector actually carries both channel A & Channel B outputs (see:
Speaker Connector Wiring Diagrams). The "Channel B" speaker
connector carries the Channel B output only. This arrangement allows
you the option of connecting to the outputs separately or together.
Connecting through a single connector has the advantage of
minimising connections, preserving phasing and simplifying channel
allocation, which is particularly important when bi-amping.
IMPORTANT
Do not overload your amplifier by connecting the channel B
output twice!
Channel A is used as the "dominant" channel and when sourcing
a dual output from Channel A, the following standard should be used:
Channel A = Left or Low Frequencies.
Channel B = Right or High Frequencies.
I N S TA L L AT I O N
I S S E R I E S I N S TA L L AT I O N & O P E R AT I O N M A N UA L