Nilfisk-ALTO NEPTUNE 8 - Manual (Page 9)

7
english
1) Options / model variants
NEPTUNE 5 / 7 / 8
3.7 Fill up fuel tank With the machine cold, turned
off and disconnected from power
supply:
1. Fill fuel tank from a clean con-
tainer with a fresh fuel (fuel oil
EL, or Diesel oil DIN 51 603),
or fuel type recommended by

your distributor.
Bio-Diesel can be used, see
notes in chapter 1.
The fuel must be free from con-
tamination.
Tank capacity see chapter 9.3
the burner. Before the winter
months it is recommended that
a fuel conditioner/stabilizer be
added (available from the fuel
oil trade).
3.8 Connecting the high
pressure hose
3.8.1 Machines with high
pressure hose reel 1)
1. Connect the high pressure
hose quick connector to the
high pressure nipple (A) lo-
cated at the hose reel axle.
2. Place the high pressure hose
into the hose guide (B) and
ritain it with the clip.
3. Release the brake (C) on the
hose reel and wind up the
high pressure hose.
3.8.2 Machines without high
pressure hose reel
1. Connect the high pressure
hose quick connector to the
high pressure nipple located
at right rear of machine above
chemical tank.
3.9 Connecting the water
supply 1. Attach quick connect adapter
found with Owners Manual to
the water supply hose.
2. Rinse the water supply hose
briefl y in order to prevent sand
an other dirt particles entering
into the machine.
3. Attach water supply hose with
adapter to inlet quick connec-
tor.
4. Open water supply faucet.
A
B
C
Technical data.
NOTE!
At temperatures below 8°C
(46°F), the fuel oil begins to so-
lidify (paraffi n precipitation). This
can lead to diffi culties in starting