Asus K8V-VM - Manual (Page 49)

ASUS K8V-VM Motherboard 2-13
DMA Mode [Auto]
Selects the DMA mode. Configuration options: [Auto] [SWDMA0] [SWDMA1]
[SWDMA2] [MWDMA0] [MWDMA1] [MWDMA2] [UDMA0] [UDMA1] [UDMA2]
[UDMA3] [UDMA4] [UDMA5] [UDMA6]
SMART Monitoring [Auto]
Sets the Smart Monitoring, Analysis, and Reporting Technology.
Configuration options: [Auto] [Disabled] [Enabled]
32Bit Data Transfer [Enabled]
Enables or disables 32-bit data transfer.
Configuration options: [Disabled] [Enabled]
2.3.5 IDE Configuration
The items in this menu allow you to set or change the configurations for
the IDE devices installed in the system. Select an item then press
if you want to configure the item.
Parallel ATA IDE Controller [Both]
Hard Disk Write Protect [Disabled]
IDE Detect Time Out (Sec) [35]
ATA(PI) 80Pin Cable Detection [Host]
Parallel ATA IDE Controller [Both]
Allows you to select the Parallel ATA IDE controller.
Configuration options: [Disabled] [Primary] [Secondary] [Both]
Hard Disk Write Protect [Disabled]
Allows you to enable to disable the hard disk write protection. This will be effective
only if device is accessed through BIOS. Configuration options: [Disabled] [Enabled]
IDE Detect Time Out (Sec) [35]
Allows you to select the time out value for detecting ATA or ATAPI device(s).
Configuration options: [0] [5] [10] [15] [20] [25] [30] [35]
ATA(PI) 80Pin Cable Detection [Host]
Allows you to select the mechanism for detecting 80Pin ATA(PI) cable.
Configuration options: [Host & Device] [Host] [Device]