K8v-vm speaker out connector speaker, Eatxpwr atx12v – Asus K8V-VM User Manual
Page 33
ASUS K8V-VM Motherboard
1-23
. ATX power connectors (24-pin EATXPWR, 4-pin ATX12V)
These connectors are for ATX power supply plugs. The plugs from the power
supply are designed to fit these connectors in only one orientation. Find the
proper orientation and push down firmly until the connectors fit completely.
• Do not forget to connect the 4-pin ATX +12V power plug; otherwise, the
system does not boot up.
• Make sure that your ATX 12V power supply can provide 12A on the +12V
lead and at least 1A on the +5-volt standby lead (+5VSB). The minimum
recommended wattage is 300 W, or 350 W for a fully configured system.
The system can become unstable or will not boot up if the power is
inadequate.
K8V-VM ATX Power Connector
EATXPWR
ATX12V
+3 Volts
+3 Volts
Ground
+5 Volts
+5 Volts
Ground
Ground
Power OK
+5V Standby
+12 Volts
-5 Volts
+5 Volts
+3 Volts
-12 Volts
Ground
Ground
Ground
PSON#
Ground
+5 Volts
+12 Volts
+3 Volts
+5 Volts
Ground
GND
GND
+12V DC
+12V DC
r
R
K8
V-
VM
6. Speaker out connector (4-pin SPEAKER)
This connector is for the case-mounted speaker and allows you to hear
system beeps and warnings.
K8V-VM Speaker Out Connector
SPEAKER
+5V
1
GND
Speak Out
GND
r
R
K8
V-
VM