Feature setup – AT&T ATT 993 User Manual
Page 23

20
Telephone operation
Feature setup
Turn automatic line selection on or off
When this feature is turned on and the telephone is off
hook, it automatically connects to a pre-selected line.
Lines are prioritized in the following order: ringing primary,
ringing non-primary, idle primary, idle non-primary, and
busy primary.
Ringing primary: When the primary line is set to Line
and Line is ringing, Line is automatically connected.
Ringing non-primary: When the primary line is set to
Line and Line is idle while Line 2 is ringing, Line 2 is
automatically connected.
Idle primary: When the primary line is set to Line and
both lines are idle, Line is automatically connected.
Idle non-primary: When the primary line is set to
Line and Line is busy while Line 2 is idle, Line 2 is
automatically connected.
Busy primary: When the primary line is set to Line
and Line and Line 2 are busy, Line is automatically
connected.
NOTE: The same logic applies if the primary line is set to Line 2.
Press
ENTER to begin feature setup.
Press until the screen displays
PHONE SETTINGS.
Press
ENTER. The screen displays PRIMARY LINE.
Press until the screen displays
ALS ON/OFF and
the current setting.
Press or to toggle between
ON and OFF.
When the correct setting is shown, press or
ENTER
to save the setting. The screen displays
PREFERRED
MODE.
Proceed to step 5 of
Set preferred mode on page 2
to set the next feature (Preferred mode).
— OR —
Press and hold
ENTER to return to the idle screen.
NOTE: If you press a LINE button before pressing SPEAKER, that
line will be used instead of the automatic line selection already
programmed. Automatic line selection will resume for the next call.
.
2.
3.
4.
5.
6.
7.
PHONE SETTINGS
ON
ALS ON/OFF