Brocks Performance ShortMeg 2 Full System 14" Muffler ZX-14R (12-15) User Manual
Page 2
Document ID 996434
Page 2 of 9
Note: A slight ovaling of the tubing can occur during the manufacturing process, this is normal.
A twisting motion may be required during assembly/disassembly.
STEP 2: Pre-Assemble Headers, Collector, and Mid-Pipe to Ensure Proper Fit
Between All Parts:
The pre-assembled system is shown (Figure 2). Pre-assembly helps to detect
any potential shipping damage and ensures that all parts fit properly. Apply WD-40® to the pipe joints
to ease assembly, adjustment, and especially disassembly.
Figure 2
Caution: During all steps below, the fairings should remove with ease. If you
feel resistance, stop and assess the situation before continuing.
STEP 3: Remove ZX-14R Dashboards:
The dashboards are held in place by three fasteners
shown (Figure 3). Note that all dashboard and
fairing fasteners have thin plastic washers
located between the fastener head and the
plastic bodywork. Save the plastic washers to be
reused later. To avoid losing fasteners and
washers, it is recommended that the installer
place them in a container. With a two-handed
grip on the inside of the dashboard, gently pull
towards the forks to release the tabs holding the
dashboard in place. Lift the dashboard upwards
to remove.
Figure 3 ------------------------->