Analog Devices EZ-EXTENDER 82-000218-01 - Manual (Page 31)

Bluetooth EZ-Extender Manual 2-9
Bluetooth EZ-Extender Hardware Reference
STAMP UART Connector (J1)
The STAMP UART connector ( J1 ) allows the Bluetooth EZ-Extender to
be plugged onto an EZ-KIT Lite development board supporting a
STAMP interface. The
J1 connector is located on the bottom side of the
board. For availability and pricing of the connectors, contact Samtec.
Refer to “Expansion Interface” on page 1-6 or more information.
Expansion Interface II Connector (J3)
The board-to-board connector ( J3 ) provides signals for the SPI, TWI,
UART, SPORT interfaces and general-purpose I/O (GPIO) signals of the
mating EZ-Board. The connector is located on the bottom side of the
board. For availability and pricing of the connectors, contact Samtec.
Refer to “Expansion Interface” on page 1-6 for more information.
Part Description Manufacturer Part Number
10-position 0.1”, SMT socket SAMTEC SSW-105-22-F-D-VS
Mating Connector
10-position 0.1’’, SMT header SAMTEC TSSH TSSH-105-01-L-DV-A
Part Description Manufacturer Part Number
50-position 0.1’’, SMT socket SAMTEC SSW-125-22-F-D-VS
Mating Connector
50-position 0.1’’, SMT header SAMTEC TSSH-125-01-L-DV-A