Automation Components ACI/Button Sensor - Manual (Page 2)

2305 Pleasant View Rd. Middleton Industrial Park Middleton, WI 53562
PH: (608) 831-2585 FAX: (608) 831-7407
I0000024.DOC Rev 4
Page 2 of 2
WALL
FIGURE 1
½” Conduit Mounting using the 1” or 2” Delrin Spacer
1. First insert the button sensor (2) wires through the top of 1” or 2” Delrin spacer. Now thread the 1” or 2”
Delrin spacer onto the back of the button sensor. Now make all of the wire connections using either crimp on
connectors or wire nuts. A small piece of foam or insulation may be inserted into the bottom of the 1” or
2”Delrin spacer to better insulate the sensor if necessary. Next insert the button sensor assembly into the ½”
conduit until it is flush to the end of the conduit as shown in Figure 2 below. You may need to tap the
button sensor assembly using a 3/8” socket and hammer for it to go into the conduit.
FIGURE 2
1/2" Conduit
If you have any further questions or comments regarding the Button sensor, please call ACI for technical assistance.
WEEE Directive
At the end of their useful life the packaging and product should be disposed of via a suitable recycle centre. Do not dispose
of with household waste. Do not burn.